External link to microprocessor circuit

microprocessor circuit

An 8086 microprocessor circuit has a memory system consisting of EPROM and RAM. 4 16Kx8 capacity EPROMs create a 32Kx16 bit memory space in the address range C0000H-CFFFFH. 4 (32Kx8) capacity RAM creates a memory space of 64Kx16 bits in the address range of 30000H-4FFFFH. Draw this system by showing the address, data and control buses. Explain in detail, showing that the system you have […]

External link to A black and white picture consist of 525 lines of picture information assume each line consist of…

A black and white picture consist of 525 lines of picture information assume each line consist of…

A black and white picture consist of 525 lines of picture information assume each line consist of 525 picture elements each element having 256 brightness levels and the picture at rate of 30/sec .calculate the average information conveyed by a TV set to viewer

External link to (a) Using the Gram-Schmidt orthogonalizarion procedure, find a set of orrhonormal basis functions…

(a) Using the Gram-Schmidt orthogonalizarion procedure, find a set of orrhonormal basis functions…

(a) Using the Gram-Schmidt orthogonalizarion procedure, find a set of orrhonormal basis functions to represent the three signals s1 (t), s2 (t), and s3 (t) shown in Figure. (b) Express each of these signals in terms of the set of basis functions found in part(a).

External link to you have been tasked with the task to determining the transmission system changes required to…

you have been tasked with the task to determining the transmission system changes required to…

EE4310-01 Fall 2020 Design Project: System Planning Time given: 5 Weeks – Due December 15, 2020 Approximate time required: 15 hours As a planning Engineer for Los Angles Gas and Electric (LAG&E), you have been tasked with the task to determining the transmission system changes required to locate a new 600MW Solar farm in the Eastern portion of your service territory (see Figure 1). LAG&E […]

External link to A 208-V, 60 Hz, six-pole Y-connected 25-hp design class B induction motor is tested in the…

A 208-V, 60 Hz, six-pole Y-connected 25-hp design class B induction motor is tested in the…

A 208-V, 60 Hz, six-pole Y-connected 25-hp design class B induction motor is tested in the laboratory, with the following results: No load: VNL = 208 V, INL = 22.0 A, PNL = 1200 W, ftest= 60Hz Blocked rotor: VBR = 24.6 V, IBR = 64.5 A, PBR = 2200 W, ftest = 15Hz DC test: VDC = 13.5 V, IDC = 64 A (i) […]

External link to Consider a 2.4GHz WLAN transmitter, radiating +20 dBm power from anisotropic antenna, is located…

Consider a 2.4GHz WLAN transmitter, radiating +20 dBm power from anisotropic antenna, is located…

Consider a 2.4GHz WLAN transmitter, radiating +20 dBm power from anisotropic antenna, is located at a workstation in an office building. It isseparated from the network access node (receiver) from a distance of 35 m.The wireless signal crosses 5 m open space of theoffice itself, then through aplasterboard wall (which causes 6-dB signal attenuation), and finally a largeopen area with a path-loss exponent of 3.1. […]

External link to D4.5. A 15-nC point charge is at the origin in free space. Calculate V1 if point P1 is located at…

D4.5. A 15-nC point charge is at the origin in free space. Calculate V1 if point P1 is located at…

Which of the following statements is true? a. An increase in demand, with no change in supply, will increase the equilibrium price and quantity. b. An increase in supply, with no change in demand, will decrease the equilibrium price and the equilibrium quantity. c. A decrease in supply, with no change in demand, will decrease the equilibrium price and increase the equilibrium quantity. d. All […]

External link to 1. Horsepower is expressed in units of ______________ . a. Pound-feet b. Foot-pounds c. Foot-pounds.

1. Horsepower is expressed in units of ______________ . a. Pound-feet b. Foot-pounds c. Foot-pounds.

1.       A turbojet engine flies with a speed of 880 km/h. Mass-flow rate of air is 50 kg/s. The isentropic change in enthalpy for a nozzle is 188 kJ/kg and its velocity as constant as 0.96. The fuel-air ratio is 1.2%. Calorific value of the fuel is 44 MJ/kg. Determine   (a) thermal efficiency,   (b) fuel flow rate,   (c) propulsive efficiency, and   (d) overall efficiency. 2.       […]

External link to 1. What are the other names for a line wrench? 2. What are the standard automotive drive sizes for..

1. What are the other names for a line wrench? 2. What are the standard automotive drive sizes for..

The temperature in a surface condenser is 37.31°C and the vacuum is 698 mm of Hg and the barometer reads 755.2 mm of Hg. Correct the vacuum reading to a standard barometer of 760 mm and hence, determine   (i) the partial pressure of steam and air, and  (ii) the mass of air associated with one kg of steam. Take R = 0.287 k.J/kg ·K for […]

External link to 1. What are the octane improvers that may be used during the refining process? 2. What is…

1. What are the octane improvers that may be used during the refining process? 2. What is…

If AD shifts by $60 for every $1,000 change in consumer wealth, by how much will AD increase when the stock market rises in value by $400 billion? If AS decreases by $50 billion for every 1 percentage point increase in business tax rates, by how much will AS shift to the left when the tax rate is raised from 35 percent to 40 percent?

External link to For the circuit shown in Fig., determine the power output of the source and the power in each…

For the circuit shown in Fig., determine the power output of the source and the power in each…

Suppose in Exhibit A-7 that exchange in the market for good X yields triangle ABE. This means that which of the following conditions exists in the market? a. Only consumer surplus b. Only producer surplus c. Deadweight loss d. Maximum consumer plus producer surplus As shown in Exhibit A-7, assume that the quantity of good X exchanged results in triangle EIH. This would be caused […]

External link to 1. List five common automotive chemicals or products that may be considered hazardous materials. 2..

1. List five common automotive chemicals or products that may be considered hazardous materials. 2..

An office of 25 people in Mumbai is to be air-conditioned when outdoor conditions are 29°C DBT and 73% RH. The required comfort conditions are 21°C DBT and 59% RH with 0.5 m 3 /min/person fresh air supply. Air is first cooled, dehumidified and then heated. Calculate the cooling coil capacity, heating coil capacity and capacity of the dehumidifier.

External link to 1. The correct location for the pads when hoisting or jacking the vehicle can often be found in the.

1. The correct location for the pads when hoisting or jacking the vehicle can often be found in the.

According to the data in Figure 15.4, by what percent did world GDP per capita grow from 1. 1000 to 1500? 2. 1500 to 1820? 3. 1820 to 1995? According to Figure 15.4, by what percentage did GDP per capita increase between 1820 and 1995 in 1. North America? 2. Latin America? 3. Africa? According to the News Wire “Saving Rates,” if a German and […]

External link to How is diesel fuel ignited in a warm diesel engine? a. Glow plugs b. Heat of compression c. Spark…

How is diesel fuel ignited in a warm diesel engine? a. Glow plugs b. Heat of compression c. Spark…

What goods do people buy a lot more of when their incomes go up? What goods are unaffected by income changes? If Apple cuts the price of the iWatch, what will happen to (a) unit sales and (b) total revenue? If all soda advertisements were banned, how would Pepsi sales be affected? How about total soda consumption?

External link to An oil filter should be hot drained for how long before disposing of the filter? a. 30 to 60 minutes

An oil filter should be hot drained for how long before disposing of the filter? a. 30 to 60 minutes

A four-stroke, gasolene engine develops a brake power of 410 kW. The engine consumes 120 kg of fuel in one hour and air consumption is 40 kg/min. The mechanical efficiency is 87% and the fuel heating value is 43000 kJ/kg. Determine the following:    (a) Air fuel ratio   (b) Indicated and brake thermal efficiencies

External link to Technician A says that glow plugs are used to help start a diesel engine and are shut off as soon as

Technician A says that glow plugs are used to help start a diesel engine and are shut off as soon as

1.       A vacuum of 712 mm was obtained with the barometer reading of 753 mm of Hg. Correct the vacuum to a standard barometer reading of 760 mm ofHg. 2.       Steam enters a condenser at 35°C. The barometer reading is 760 mm of mercury. If the vacuum of 690 mm is recorded, calculate the vacuum efficiency.

External link to 1. What are the strokes of a four-stroke cycle? 2. If an engine at sea level produces 100 hp, how…

1. What are the strokes of a four-stroke cycle? 2. If an engine at sea level produces 100 hp, how…

Define the following terms: fiscal policy, aggregate demand, consumption, investment, net exports, equilibrium (macro), GDP gap, fiscal stimulus, saving, marginal propensity to consume (MPC), marginal propensity to save (MPS), multiplier, disposable income, fiscal restraint, budget deficit, budget surplus

External link to A 3f, 25 kV, 500 MVA, 60 Hz alternator has a synchronous reactance Xs = 1.5 pu. The alternator is…

A 3f, 25 kV, 500 MVA, 60 Hz alternator has a synchronous reactance Xs = 1.5 pu. The alternator is…

1.       What is the importance of the interaction between stress level and cue-stimulus interval? Can you think of some examples? 2.       Discuss possible interaction between traffic density  and road curvature when using a secondary task to measure attention demands of driving.

External link to 1. What is the difference between direct injection and indirect injection? 2. Why are glow plugs…

1. What is the difference between direct injection and indirect injection? 2. Why are glow plugs…

In an axial.flow compressor, overall stagnation pressure ratio achieved is 4 and overall stagnation isentropic efficiency is 85%. The inlet stagnation pressure and temperature are 1 bar and 300 K, respectively. The mean blade velocity is 180 m/s. The degree of reaction is 50% at mean radius with relative air angles of 12° and 32° at rotor inlet and outlet, respectively. The work done factor […]

External link to 1. To determine if a product or substance being used is hazardous, consult ________ . a. A…

1. To determine if a product or substance being used is hazardous, consult ________ . a. A…

Tom sustained a neck injury playing college football, resulting in incomplete quadriplegia; he has movement in both arms and legs, but some of the movements are minimal or poorly controlled and therefore not functional for locomotion. His long-term mobility prognosis is unsure but optimistic If Tom continues to improve, what would be his likely progression through assistive gait devices?

External link to 1. What type of screwdriver should be used if there is very limited space above the head of the…

1. What type of screwdriver should be used if there is very limited space above the head of the…

Suppose the long run price elasticity of copper demand were -0.75 instead of -0.5. a) Assuming that the equilibrium price and quantity are P* = $3 per pound and Q* = 18 million metric tons per year, derive the linear demand curve consistent with the smaller elasticity: b) Using this demand curve, recalculate the effect of a 20% decline in copper demand on the price […]

External link to 1. Gasoline should be stored in approved containers that include what color(s)? a. A red container..

1. Gasoline should be stored in approved containers that include what color(s)? a. A red container..

a velocity of 850 m/s. The nozzle angle is 20°. Mean blade velocity is 350 mis and the blades are equiangular. The mass-flow rate is 1000 kg/min. The friction factor is 0.8. Determine:   (a) Blade angles, (b) Axial thrust on the bearings,   (c) Power developed in kW,   (d) Blade efficiency,   (e) Stage efficiency, if nozzle efficiency is 93%.

Calculate the price of your order

550 words
We'll send you the first draft for approval by September 11, 2018 at 10:52 AM
Total price:
$26
The price is based on these factors:
Academic level
Number of pages
Urgency
Basic features
  • Free title page and bibliography
  • Unlimited revisions
  • Plagiarism-free guarantee
  • Money-back guarantee
  • 24/7 support
On-demand options
  • Writer’s samples
  • Part-by-part delivery
  • Overnight delivery
  • Copies of used sources
  • Expert Proofreading
Paper format
  • 275 words per page
  • 12 pt Arial/Times New Roman
  • Double line spacing
  • Any citation style (APA, MLA, Chicago/Turabian, Harvard)

Our guarantees

Delivering a high-quality product at a reasonable price is not enough anymore.
That’s why we have developed 5 beneficial guarantees that will make your experience with our service enjoyable, easy, and safe.

Money-back guarantee

You have to be 100% sure of the quality of your product to give a money-back guarantee. This describes us perfectly. Make sure that this guarantee is totally transparent.

Read more

Zero-plagiarism guarantee

Each paper is composed from scratch, according to your instructions. It is then checked by our plagiarism-detection software. There is no gap where plagiarism could squeeze in.

Read more

Free-revision policy

Thanks to our free revisions, there is no way for you to be unsatisfied. We will work on your paper until you are completely happy with the result.

Read more

Privacy policy

Your email is safe, as we store it according to international data protection rules. Your bank details are secure, as we use only reliable payment systems.

Read more

Fair-cooperation guarantee

By sending us your money, you buy the service we provide. Check out our terms and conditions if you prefer business talks to be laid out in official language.

Read more